Make sure you are running the PTO near 500-540rpm. Big difference in pump pressure when running slower than rated PTO speed. Aside from that, my guess is your control valve unit needs to be rebuilt.
Also, FYI, in my experience with #30 ejectors, if you run the ejector over 6 to get heavy bales (60+ lb) into the wagon, you are going to break the H frame at the pivot point (most have already broken and show the typical welds and re-welds). So, once you get things running normally, be careful when using the higher numbers on the control valve with heavy bales. 6 should be plenty to throw 45-50lb bales over the back of an 18ft wagon if the ejector is working properly at 500+ PTO speed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.