Posted by Erik ok on July 14, 2013 at 19:42:35 from (70.128.123.165):
I have gone over the baler manual and the knotter service manual and made every adjustment per the book so I think anyway. Now the problem is the right side knotter is missing every single knot, no loop on either end of the twine. The ends are kinda ragged looking, just put new twine knives on yesterday. I adjusted needles, twine disc timing, twine fingers, twine holder, twine box tension per the manual instructions but still no knot on right, left side ties perfect every time and I have tried to set the right side up the exact same. The book shows failed knots but not one with no loop on either end, I'm using 9000 poly twine, thinking about trying some sisal to see if it makes any difference, anyone have any other suggestions? May have to break down and take it to the dealer and have it checked out, I was able to bale about 20 bales in 6 hours of messing around with it today, becoming very frustrating.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.