Posted by Leroy on May 04, 2013 at 05:32:41 from (69.88.205.38):
In Reply to: Re: JD KBA-7-10 Disk posted by David8686 on May 03, 2013 at 15:34:01:
And that disk 16" was normal with 18" on some and common to be worn down less than 15" but the 16" will not do as good a work as the 18" but were sold by price as they were cheaper and at one time it was though that 16" blades cut better and pulled easier than the 18" but that is opposite of fact. Now I do not know if there would be frame clearance for a 20" blade and they are thicker so you might have a problem getting them in because the bearing spacing is fixed and then total axle length might be a problem as well. Orignal blades were probably 11 guage, current replacement 9 guage and 20" would be 7 guage. The thicker the blade the more weight it needs to cut.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.