I didn't call Shoup, but I couldn't find that model listed in there catalog, It's not a regular sealed bearing. Perhaps I didn't explain my problem well enough. The nuts came off the gangs OK. The cast iron 1/2 spools next to the outer bearings are filled with dirt from being run loose a long time before I bought it. The spools are rusted tight on the shaft as well as some of the bearings. I heated the cast spools hoping they would expand and I would be able to drive them off then. I have 2 of the main gangs apart, 1 main gang back together, 2 of the wing gangs apart and 1 back together. The gang shafts are wore from the blades being loose, so I have welded the groove up and ground them off smooth. Try to get some more done tomorrow night and then work on it Saturday. Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.