Posted by rockyridgefarm on January 29, 2013 at 07:49:23 from (69.131.203.82):
Hey all,
About a month back, I posted seeking advice on weld-on replacement rotary hoe spoons. I found the company that builds them in Canada, and they sent me a sample bit. They're 2 3/8 inches long and 3/4 inch wide. They cost $13.60 per wheel, plus shipping. The company is Manufarm and they're in Wheatley, Ontario - just across the border from Detroit. Their number is 519 825 7354
The bits look like they'd make a hoe much more aggressive when used for blind cultivation in the early season. The owner warned me that you can't go as fast with the hoe in beans or you'll tear them to pieces - but it'll do a better job at lower speeds. Frankly, 10-12 mph on my ground is suicide. I'd rather run 5-7 mph, do a better job and stay off the row more consistently.
My original plan was to buy new wheel assemblies from an aftermarket dealer. They're $30-$45, depending on vendor, and I heard some negative feedback on longevity. I did buy one from Sloan Express ($34), two from THE Company($41), and one from Mother Deere ($54). I'm gonna do up the hoe with Ho-Bits on the rows and mount the aftermarket ones as well in order to see how long they last and how aggressive they are on weeds.
If you're close to me (Southwestern Wisconsin), I ordered more than what I needed with the thought that I could sell them as a dealer.
This post was edited by rockyridgefarm at 07:51:59 01/29/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.