I am laid-up from a complete shoulder re-construction.. have to keep my rt arm immobile for another 5 weeks (7 weeks total).. Sure glad I waited to go to the Dr until I had all the fall work done..!! Going to take until Spring, to get this back..! Anyone up there be interested in my 630 LP..?? Make one Heck of a good deal on it...90%+ done... Hope you find a chute for your baler... I don't think I ever saw a baler with the capacity they have..Dad figured if conditions were right, it took 5 to 6 strokes to make a 65 lb bale..(maybe heavier than that)..!! About 9 or 10 per minute.. My folks shower JD that it was possible to splice the wire and not have to re-thread, to replace coils... Keep in touch..!
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.