Posted by Dick L on December 20, 2012 at 08:23:53 from (126.96.36.199):
In Reply to: 14 T knotters posted by david1 on December 18, 2012 at 15:43:59:
Not a 14 T but I had a bill hook on my NH 277 that the cam had worn enough to close tight on the knot before the wiper could strip it. I ended up moving the flywheel an inch or so after tripping the knotters to see what was going on. I lot of steps from the flywheel to look at the knotters but was able to find my problem. I also had a bent shaft that moved the twine fingers as well as one of the twine finger brackets bent and the bushing wore out.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.