Posted by Leroy on December 03, 2012 at 04:12:31 from (69.88.205.38):
In Reply to: Re: Oliver plow woes.... posted by Crazy Red Power in SE-WI on December 02, 2012 at 20:30:33:
Mike, the shares for the 4 bolt are designed for a different landside than the 3 bolt shares as they set an aditional 1/2" to the left and the landsides for them either have a bend to put the back of the landside out that much farther or have a replaceable pad bolted on the back. Are your shares the plain flat blade style or the style with a nose for better suck? Flat blade I think grinding is only way to sharpen and then only once as nose becomes too short, style with a nose like the old blacksmith style share can be sharpened same way as the blacksmith sharpen share, if you were here I could teach you how to do it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.