Posted by maxwell99 on December 02, 2012 at 19:07:34 from (208.137.161.83):
I have a 6ft Altas 300, 3 pt disc, it has 18" blades and all notched blades, front and rear gangs.
Nice disc and cuts good, but it leaves a deep ditch on the outside of each rear gang.
i have tried pulling a drag, but the outside rear notch blades catch on the drag and sometimes, bind up the rear gangs,
would it be possible to cut the rear gang, outside blades down some, say 3 inches, this would cut the notches out of the blades back to a smooth blade,
this might stop the rear blades from catching my drag and also leave smaller outside furrows.
another thing I have seen is sometype extention you weld or bolt onto the outside blade that has an smaller disc blade and this blade fills in the ditch of the regular outside blade,
do not know if this trick would stop the notch blades from catching the drag.
any ideas would be helpful before next years garden plowing starts.
this year i just did not use my drag, but it left the gardens rougher.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.