Posted by Leroy on November 19, 2012 at 05:42:24 from (69.88.205.38):
In Reply to: Mowing hay posted by Shale on November 18, 2012 at 17:19:21:
Unless you have a selfpropelled unit or a pulltype that you can swing from the tractor seat while you are turning at each end and cut all the field from same side then the only sencible way is round and round as without that you would be spending a lot of time and fuel wasted to travel across the ends and unless you waited to mow the rest of the field till you had the outside rounds baled they would be ruined from driving on them and even if you did that then you would be doing damage to the crop for later cuttings. This is all with a mower that only cuts on one side and unless you are a big time operator you usually will not have that hydraswing or selfpropeled unit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.