Posted by RickB on October 05, 2012 at 13:54:56 from (68.237.141.131):
In Reply to: Du-Al mfg--seals needed posted by Steven Miller on October 05, 2012 at 07:44:17:
"This message is a reply to an archived post by Bob Rose on July 07, 2008 at 12:57:07. The original subject was "DuAl mfg Sioux Falls S. Dakota parts needed". I know this is an old request, BUT for anyone installing seals in Du-Al"s old style hydraulic cylinders (seals roughly look like the sidewalls of tires), these cylinders MUST NOT be used with modern hydraulic fluid because it will dissolve the seals. The old style cylinders were designed to use old motor oil. " Steven is dead wrong. U-cup seals are still used extensively on older cylinders using all manner of modern hydraulic oils. Prime examples are Ford industrial backhoes and loaders built before about 1980. Ford never specified engine oil for these hydraulic systems (1965 to 2000).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.