Posted by Weldon K on September 27, 2012 at 18:52:55 from (71.31.204.75):
In Reply to: NH 824 corn head posted by krm1976 on September 26, 2012 at 18:41:05:
824 heads are adjustable in 2 inch increments from 28 to 40 inches. They were shipped from factory with narrow row sheet metal or wide row sheet metal. Narrow row sheet metal adjusts 28-30-32-34.Wide row sheet metal adjusts 34-36-38-40. If owner wants to adjust from 30" to 36" or wider requires a conversion kit (which is all the sheet metal parts of the center snout and covers). Lots more stuff has to be unbolted and locations shifted plus gathering chains must be re-timed. It is a time consuming job. You definitely need owners manual to do it correctly. Call a dealer and order one or perhaps you can order one from New Holland website. We bought a 824 10 years ago. It was a narrow row from factory set at 30 inches . We grow 36 inches. I set the space at 34 and it works with no problems.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.