Posted by Brian Waddell on September 24, 2012 at 17:21:08 from (22.214.171.124):
We have a 3 row narrow corn head that has seen very little use to go on the 881 forage harvester, we purchased 6 new gathering belts and installed them. The drive clets on the two belts on one of the outside rows want to climb out of the plastic idles sprocket at the bottom or open end where the corn meets the cut off knives, this results in the all the belts being very hard to drive. There are 4 belts with one particular part number and 2 others, thereby being unable to install incorrectly. Does anyone have any advise. Thanks
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.