A couple of things, a JD 2640 was 70 hp with 276 ci engine. Watched a neighbor with a 3020 diesel with small 2 row cut and blow and it had a hard time running it (hay or corn). Another neighbor tried his JD 3800 on an IH 784 tractor and lacked power to move out of lowest gear. He made sure he got his 856 diesel up and going ASAP. Cutterhead on a 900 is designed for 3 row capacity along with the drive line. Takes more power to spin that (even no load) than a NH 790, JD 3950, etc. You MIGHT get the 2640 to run it, but you will be disappointed with minimal productivity. If you have a choice in this, I would look at going up more hp or find a smaller chopper in that order.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.