Implement Alley Discussion Board |
Re: Bottom plow setup
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Leroy on March 08, 2007 at 17:32:42 from (216.201.38.88):
In Reply to: Re: Bottom plow setup posted by Randy as in Randy-IA on March 07, 2007 at 18:06:03:
Randy, I think I gave you that formula when you bought the plow. Yes it will work with the wheels set narrower but you are more likely to have the front end want to pull to the right instead of staying in a straight line. I had a Massey-Ferguson 4-14" semi mount plow and a Ford 5000 with 15.5 X 38 rear tires. Normal tread was 60" on center, I kept the left wheel on that and had a dual on that side, the right wheel I put on a 72" tread setting, (36" center of tractor to center of right tire, never did measure to inside of tire), that is center of tire to center of tire. That brought me to the correct center line of draft so it didn't want to pull the front sideways like if I would have had the hitch set for the 60" tread setting like it was setup for when I got it. It was also easier on these old bones as with the tread set out the tractor rode more level than with the narrower tread setting. That problem is what you will come up with your M as you cannot safly set the wheels narrow enough to use that formula, just have to have the wheels set far enough apart to be safe with tilt of tractor, and hook up as best as you can to get plow to follow and the wider the wheels are apart and the harder the ground pulls the harder the front end of the M will want to swing to the right.
Replies:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|