Implement Alley Discussion Board |
Re: Opinions of a New Holland 68 square baler
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scott Griffith on September 21, 2006 at 19:32:51 from (66.23.231.231):
In Reply to: Opinions of a New Holland 68 square baler posted by jswintx on September 21, 2006 at 11:18:54:
I have a new holland 68 with the Wisconsin THD two cylinder engine. You can still get the manual for the engine free from Wisconsin's website and the parts for the mag at your local napa most of the time. It's a good little baler once you get it adjusted right. If it were sitting out for long and needed a lot of sheet metal work and gearbox work then I wouldn't touch it with a ten foot pole. You'd be a lot happier after being tared and feathered. My two cents... Scott
Replies:
Home
| Forums
Today's Featured Article -
Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|