Posted by ih_bug on February 08, 2014 at 19:44:57 from (206.132.54.197):
In Reply to: IH 403/150 drill posted by sixtyninegmc on January 30, 2014 at 18:44:53:
just a tip on the big flat drive belt if it needs replaced get a multi vee b section belt. wrap a tape measure around the pulleys and match a lenght up then get one wide enough. dont try and splice it will just drive you nuts and keep pulling in two. the multi vee will run straight and will have enough traction to stall the engine . it does on a 503 anyway so i am sure it will on a 403. all belts and bearings are starndard sizes and very few on it anyway. get a good belt pickup make the mounts to bolt it on and drive it off the reel drive. you may have to twist the belt . the hydro is the same as 715 and I think newer machines as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.