This is what I do on my case Ih combines and I've never had any problems with rust, bearings or mice. Take off every shield possible. Blow off thoroughly. Flush everything out with a garden hose, including the insides, until no more grain comes out. I park the combine on a slope so all water runs out of clean grain auger and then turn it around so all water comes out bottom of unloading auger. Then pressure wash everything. Let it dry off and look for spots I missed. Pressure wash some more. Flush and rinse with garden hose again. Hand wash sheet metal. Meticulously clean cab. Wax. Spray all insides with diesel fuel and oil. Lube all chains and grease everything and then engage separator and run it for 15 minutes. Then i make a list of everything i need to repair before i forget. This makes it so much better when working on it in off season and if there's no grain or dirt you won't have any problems with mice. It takes me 3 hard days to get mine ready to park. I don't know about the JDs, but Case IH designed their machines to where you can thoroughly clean out the insides with water and not leave wet material trapped
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
