Posted by semper fi guy II on November 22, 2012 at 03:32:45 from (22.214.171.124):
In Reply to: JD 213 Head posted by super99 on November 22, 2012 at 03:17:48:
Yes, this is a problem. I usually place a 4x4 post along just under the sickle bar to give it some tilt for the next time I want to pick it up. But now once it's on the ground flat I jack up under one of the snouts with a HandyMan jack and block it. Sometimes this can be squirrely but it's the only trick I know about this topic. Go easy and don't bump the head with the combine when you pull up and knock it off the blocks that tilt it back.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.