Posted by Paul swPa on October 30, 2012 at 21:36:43 from (22.214.171.124):
In Reply to: Re: 4420 hydrolics posted by sideconsole4020guy on October 30, 2012 at 18:24:37:
After thinking about it awhile, and talking with the service guy at deere (he didn't know, and couldn't find out from the book either) that's what I was thinking. Groove up would allow more oil to flow back in, i.e. when lowering the reel, and less oil pass when going out, i.e. raiseing the reel, because the flat side will seal somewhat against the fitting allowing oil to only pass thru the restrictor hole. Giving better control raising the reel at engine speed. Thanks Sideconsole4020guy.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.