Posted by Tom Arnold on March 28, 2010 at 13:39:39 from (70.26.133.80):
In Reply to: Re: Ingersoll 4020 posted by Longknife on March 28, 2010 at 09:48:47:
There really is no such thing as "centering" the pump. The pump slides into the coupler and you tighten down the set screws. So if your pump is jumping around, then there is a problem that must be found and corrected.
Maybe the pump shaft is bent or damaged. Perhaps it's the coupler or the shaft that comes from the engine flywheel is bent. It doesn't take much of a bend to create a real problem and you need someone who has a dial indicator mounted on a magnetic base to check the runout of the shaft.
I have a friend that bought a Massey (made by Ingersoll for Massey) that had this problem and it drove him nearly crazy trying to cure it. His was so bad it was actually breaking the coupler.
You may have to pull the engine out and take it to a machine shop for the run-out test.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.