Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Garden Tractors Discussion Board

Re: John Deere 318 Clicks but does not start right


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by George Barboza on August 25, 2006 at 19:40:58 from (72.83.156.46):

In Reply to: John Deere 318 Clicks but does not start right awa posted by Jack in Michigan on August 20, 2006 at 04:48:27:

I assume that your problem is just like an automobile. The solinoid is the low current side of the starter circuit. It is essentially a switch that is used to control the high current path from the battery to the starter. Two or three things could cause the problem. First clean the cables at the battery between the cables and the battery terminals. If you don't have a battery brush, get one at the local auto store. If the engine cranks strong when it cranks then the battery and connections are likely to be good, The next two possibilties are the solinoid, the low current switch ot the starter itself or the starter itself. The solinoid switch has a copper disk and a magnet that pulls that copper disc against the two high current lugs that attach to the battery on one side and the starter on the other. If the copper disk is pitted bad the solinoid must be replaced assuming that you can find one without having to buy the starter with it. The other possibiltiy is the starter. Inside the starter is an armature that has copper bars located around the circumference of the communtator, If one of those bars is pited or burned and the starter stops at that point then you will get a click-click and then maybe a start. The final possibility is the connections between the ignition switch and the solinoid. Find these tighten and clean them. When all else fails replace the starter/solinoid assembly.


Replies:




Add a Reply

:
:
: :

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy