Posted by johnlobb on July 31, 2013 at 17:54:51 from (184.108.40.206):
In Reply to: Mower blades posted by Vern on July 25, 2013 at 21:27:31:
Last fall I bought a pipefitters tri stand/vise and discovered that the vise set up outside works really good for cleaning and sharpening mower blades. I power wire brush them off with a side grinder mounted brush then sharpen them with a grinding wheel on another side grinder I then balance them on the cone on a point then give them a coating of Mo-Deck (avail at walmart)which keeps the grass from sticking so tight to the blades.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.