As a not too strong 77 year old mowing with parts of three 212,&214s, two 47" decks,for the last 15 years and keeping 5-6 acres subdued in Iowa generous rainfall let me offer some advice. 1. lofting the front of the tractor on some kind of ramp, allows a person laying on the ground with a 9/16" wrench to loosen the one bolt holding the blade, just align the wrench parallel to the blade you hold with a gloved hand, and unscrew. Others are right, it is a normal right hand thread. 2. When putting on the new or resharpened blades, be sure all three have trailing edge turn up pointing up! Lube the bolt with never seize and it will be easier the next time. 3. Steve is right, he has listed all the moves to remove the deck. Some more advice, tho. The deck has to be removed at least seasonally to access the belt gallery on the deck top. This arrangement causes grass to accumulate in the serpentine belt system and the deck SHOULD NEVER BE HOSED DOWN FROM THE TOP...the water collects in the gallery and rusts out the deck! 4. Removing the deck sideways from under the tractor as described by Steve, is best done with the tractor on a smooth concrete surface with at least 6 feet of clearance to one side or the other. The gage wheels do not slide easily sideways. 5 When reversing the deck installation, take care the the main drive belt is reeved through the pulley correctly and above all, watch the the belt keeper on the first set of bend pulleys is outside the belt path, don"t make the belt slide over the outside of this dingus or in a matter of a smokey few minutes you will need a new belt. 6. This old deck has a great capacity (by design)and gives good service. I know, I have double (lapped) mowed grass and weeds as tall as the tractor and the rototiller gear (super low) comes in handy when a real hay mower should have used.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.