Posted by IrvIA on January 13, 2013 at 20:15:50 from (207.199.229.145):
I'm putting this tractor back together after about a year and I've got these two rods left. I'm almost sure the small one goes on it but I'm not sure about the other one. I need a really good knowledgeable J D guy to help me out. I don't know of any other ones in my area to look at. I went to the dealer and we looked at every page on his computer parts list to no avail. I've got an operators manual for it but not a parts manual. I'm also having trouble with the variator not working. Every thing under there looks good. I've had it apart, made sure the pulley center will slide back and forth, put on both new John Deere belts and adjusted it according to the manual. I doesn't feel like its hooked to anything when you operate the lever back and forth. I have this spring left also but I thought it might go on the 48" deck. The decks back where I can't readily get at it to assemble it so I'm not sure. Any ideas?? Thanks Irv PS looks like my picture posting needs some work too. Couldn't figure out how to get rid of three of them without starting over!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
