Posted by cdmn on April 21, 2011 at 15:36:53 from (66.228.231.173):
In Reply to: Fordson Pinion posted by MT RON on April 18, 2011 at 14:18:18:
If it's got "industrial" gear ratio, you might be able to pull start it. Otherwise, don't try pulling except slowly in neutral. Industrial tractors were made to drive 25 mph on roads. Model T trucks and Peugeot cars used worm drive rear ends and the ratios were fairly high speed. You have to use worm gear oil in the rear ends. Otherwise it may not be slippery enough. At one time this was whale oil. That's now illegal and old stocks have been used up. There are synthetic substitutes using animal fats.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.