Posted by Mark Benjamin on August 10, 2013 at 07:05:58 from (65.111.219.23):
In Reply to: Jubilee Wiring posted by Mark Benjamin on August 09, 2013 at 07:50:27:
Thanks guys. I drove this tractor home a couple years ago when I bought it and actually put it to work a few times before I ran into troubles with engine, etc., and decided to rip into it. Attaching a few pictures of what I was working with. The charging system seemed to be OK so I know the cobbled mess of wiring somehow worked! I have a few diagrams and I'm posting the one I think is closest EXCEPT I don't see the wire from the coil... Never been really great with wiring so starting to get frustrated. Want to make her run after a complete engine rebuild before I put the sheet metal back on!
Question? CAN a 6V generator be used on a 12V conversion??
This post was edited by Mark Benjamin at 07:09:51 08/10/13.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.