Posted by Not so old Todd on July 25, 2013 at 08:32:45 from (22.214.171.124):
Working on helping Old Jim fix his Ford 600. Decided we will not find an output shaft for a Sherman Trans in a Ford 600 anytime soon. Question is will any 10 spline Sherman from an N series fit the 600? Or can we take the Output shaft out of an N w/ sherman and put that into what I think is a third Gen Sherman in the 600. My understanding from Smith's site is yes, but thought you guys might know for sure before I go searching. Thanks for all your help,
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.