It rides against #80 the main pivot that the cylinder pushes on to turn the shaft to raise/lower. Now I see why it is a bear if it has to be welded on. Let's just hope that only the pin is worn...
I didn't realize the cylinder was part of the top cover. Should one renew the o-ring and backup ring on the cylinder while in there or don't those go bad.
Currently if you have a load on the arms, they slowly leak down in about 2 hours with the engine off. With the engine on, you can feel it "bump" the arms up slightly every 30 seconds or so. Barely any measureable lift, but you can feel it if you have a hand on the mower or lift arms. Does that mean cylinder issue or other items...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.