Posted by karl f on June 05, 2013 at 20:22:14 from (172.129.34.92):
My brother changed the injectors on our 5000. He says it started right up and ran fine, but he saw leaks on the injector bodies. He took the lines off and tightened the injector bodies. (aftermarket parts) Then it was only running on a few cylinders. Then he asked for my help. I determined which cylinder wasn't firing--nothing but foam at the injector and then it started running on 2 cylinders, the adjacent injector was foaming too. There's no air in the filter or pump when you open the bleeder screws. A few days later, I try again--this time I use the crank at full throttle with stop pulled and lines cracked bleeding method (forgot about that before). I got back the first cylinder but the second is still foaming even after lots of cranking and running open time. I think it's the injector pump at this point. There's still no air at the bleeders so there has to be a check valve or plunger problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.