pump should move EZ enuff it would fall out on its own... A wire plumbers brush will clean up the bores...
Make sure all the passages are clean run a wire thru'em if need B
Make sure the accelerator check valve checks one way...
The metering body to carb body gasket needs to fit dead nutz perfect you may have to trim it were it butts again the carb body and make sure it stays aligned while nailing the metering body down...
I have repaired 8 are 10 of'em and all have performed great... Its as simple a carb as it gets but unlike most tractor carbs its more like a automotive carb... They can not be beat when they are right...
I have done over a 1000 and maybe 2000 automotive carbs I felt right at home with them... It would not make me mad if I never see another carb again I like EFI... BTW I use TISCO kits and have had good luck with them other than having to trim the metering body gasket to fit a tad...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.