Posted by WayneB on February 28, 2013 at 10:29:17 from (132.159.85.146):
In Reply to: ford 4000 backhoe posted by decatur on February 26, 2013 at 17:38:14:
On my 3-cyl Ford 4000 AG tractor, I had the same problem. Those two bolts under the bolster can only come out 'RIGHT' with the engine pulled. I took a 4" grinder with a cut-off disk and cut them just below the pan, turned them with a wrench until they were cut into. Slid the pan out, loosened the cut-off bolt with hand or vice grip, and when I put it back together, used short almost stubby bolts with 1/2" shank and no lock washer. Course, I did my job in the field where I had been bush-hogging and damaged the pan. Used a 3K inverter powered of my gator. So my work environment wasn't as good as a shop, so you'd have so many more options in your shop. Wayne
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.