Posted by Roel.Belgium on January 23, 2013 at 13:22:11 from (178.117.17.90):
Hello Guys,
It has been a while since my last visit to this forum. First off I would like to wish you all a very happy new year and that you all may stay happy and healthy !
Winter has come, also in Belgium. I bought this Calix heater from the internet for our Ford 6410 Generation 3 - rotative pump 4liter block. its a 1500Watt model , cold water is supposed to come in at the bottom and hot water should come out on the top. My question is , where on the right hand side of my block should I connect the hoses ? also after i connected the hoses is there no danger that I changed the cooling loop of the block and that walter would circulate not enough or start circulating in the wrong way (through the heater) ? Your professional help is much appreciated :-) Thanks in advance guys. regards from Belgium,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.