Darrell, I did this job on my 3400. Similar parts involved. On mine I installed a "speedi-sleeve" which is a thin stainless steel sleeve that is a tight fit to the steering shaft. The purpose is to provide a smooth surface for the new seal to ride on. If your shaft is pitted with rust, it will tear up your new seal and your leak will come back. My speedi-sleeve came with the seal also. The sleeve is not hard to install and worth it if it saves you doing it all over again. You may not need it, but check the shaft carefully for pitting once you get things apart.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.