Posted by WayneB on December 30, 2012 at 06:35:36 from (67.142.174.23):
Just finished putting my Ford 4000 4x4 back toether Had to split it to clean the hydraulic screen and change the filter. Screen was easy, but getting to that filter is hard. But on a 4x4 model, almost impossible. This is the last time I do this!
I'm adding a remote hydraulic filter. Will be running hard steel pickup-return lines from the bottom plate at screen to a timing gear driven pump. Loader worked well of just rear hydraulics, so should be better with T-gear pump with twice the flow. Had weep leaks at transfer to housing gaskets. Seems my bolts were too short, not catching threads deep enough. Longer allen head bolts and Nord-Lock washers and its forever tight.
Have a complete rear end to rehearse the job, but it was 2wd. will be selling that, don't look like it will be needed.
Everything other than filters looked good inside. Pulled pto shaft, new bearing seals and lock washers. My pto clutch and brakes worked good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.