Posted by Mal(Pa) on December 23, 2012 at 17:23:06 from (22.214.171.124):
Hi fellas, I have put a new Zenith b6nn8510a carb on my Ford 860 as it"s the one that model calls for. All of the searching I have done on the internet tells me how to adjust the idle speed(I know that one) but then it tells me how to adjust the "idle adjusting needle" and the "power adjusting needle". The problem is that it only has one adjusting needle besides the idle speed screw and it is near the top.I'm lost at this point so does anyone have the answer? Thanks,, Mal
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.