Posted by Keith Williams on November 15, 2012 at 04:49:59 from (24.142.137.38):
In Reply to: Coil 3400 posted by billy the kid on November 15, 2012 at 03:16:33:
Billy the kid, First lets start with: "Well I have power at the coil on start and run. I tested with a test light. I guess I need to put a volt meter on the coil input wire to see what I get. When I jump the coil the old girl will run."
When you jumped the coil, You supplied power. It must have not had enough power already!
"Why would you need a resister with a 6 volt coil but I can replace with a 12 volt coil and not need one?"
Long story short. You need a certain amount of current to run through the circuit (as in Amps) to create a spark. Amps equals volts divided by resistance. The problem is volts are different when you start vs when running. Maybe 8 volts left when you crank the engine. Around 14 volts when the engine is running and the charging system is working.
So the old way to do that on a 12 volt system was to run two wires to a low resistance coil (called a 6V coil). Wire number 1 came from the starting circuit, since the voltage is low when starting, no additional resistance is needed. Wire number 2 comes from the running circuit, you need resistance to limit the current, so they add a ballast resistor. In both cases the current is enough to create a spark.
Now the coils (called 12 volt) can be placed directly in the circuit and are able to produce a spark and limit current under both the start and running conditions with out additional resistance. These coils are marked "No resistance needed".
I hope this brings to light some of the info you need. JMOR or several others can explain more if you need it. Just let us know if this is enough. Keith
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.