Posted by jwhalin on September 25, 2012 at 09:33:35 from (12.153.21.30):
Hey can anyone help me with a Restored NAA ignition 12V Negative Ground Ignition Circuit? I have on my ignition circuit: Battery Cable to Solenoid, +DC from Solenoid to Ammeter, through the ammeter, Ammeter to Batt on Ignition switch, Under same lug on ammeter as +DC from solenoid, I have cable going to Batt on Altenator. From other side of solenoid I have cable going to starter. From small lug on solenoid, I have wire going to ST on ignition switch. Lights are hooked up on ACC on ignition Switch. #1 lug on Altenator is hooked up on IGN on ign switch. #2 on Altenator is bonded to BATT from Altenator going to one side of Ammeter. Tractor started fine ran good for 10 minutes, then died. I had installed Petronix Electronic Ignition 2 years ago. Changed Coil and tractor started and ran well. Went to turn key off and tractor would not shut off? What have I done wrong? Please Help!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.