Bern, Thanks so much for taking time to respond. This is my first time using this forum so bear with me. I am sending this expanded version of my problem to all responders. You all sound much more knowledgeable about Ford tractors than myself. I am strictly a jack leg, with some mechanical background. Not sure I know what dead-head refers to. The ford tractor dealer I have been able to gleam some info from, told me that first I must determine the pump pressure. He said it should be appx. 1200-1500 at the stops (wheels turned completly I assume). I purchased a hydraulic pressure gauge and installed it with a T connector in the output line. With engine running pump reads 0 pres. until the steering wheel is moved at which time it reads about 500 psi to the left and only 200 psi to the right. This is with the front wheels full on ground and wheels only turn slightly. If I raise front wheels off ground I can then turn left to the stop and gauge reads 1000psi. To the right however wheel turns completely to the stop but steering wheel will keep turning and pressure is only 500psi. I removed the pump, disassembled, order a seal kit and replaced kit seals. Pump looked tight internally. problem still there. I have since taken out the steering motor and disassembled. Very intricate device. Internally it looks like a small rotatory engine. Internal parts look to be ok, haven't gotten motor back together yet. I have also removed and inspected the wheel cylinders and both appear in good order. I suspect my steering motor. New, this item is $1K. Do you know of any sources for used parts of this type? P/N 86604767
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.