Ford Tractors Discussion Board |
Re: Re: Re: Re: How to remove inlet valve seats in hydro. pump
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Richard C. Rose on September 06, 2001 at 04:57:45 from (203.96.111.202):
In Reply to: Re: Re: Re: How to remove inlet valve seats in hydro. pump posted by -mike in fla. on September 05, 2001 at 05:47:07:
Wow that was a bit strong Mike, I appreciate how aggravating struggling with something you get to realise you should never have started can be. I can assure you I have rekitted dozens of these pumps successfully and have actually made a sleeve and threaded rod tool for pulling the seats out rather than use a slide hammer, although I believe a slide hammer could work if used correctly. I advise in this forum only on work I am familiar with and have undertaken regularly, I believe my advise is accurate and I try to make it clear but their are two variables I am not in control of: 1: The accurate discription of the symptoms 2: The level of skill and competancy of the person applying that advise to the job. There are a couple of things you needed to work out for yourself, wether the hole needed to be opened up some more to be tapped, wether the tap was of sufficient quality to cut the steel and to recognise the difference between the valve seat and the parent housing. Basically once advice is given you and only you must decide wether you are confident enough to undertake the work. You know you can take it down the road, pay a few extra bucks and get a guarantee. You decided to gamble and do it yourself. Remember, advice here is free, maybe thats what it is worth to some. Regards Dicko
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|