Ford Tractors Discussion Board |
Re: Re: Re: Ford 3000, hydraulic/transmission fluid level
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MacL on June 03, 2002 at 09:17:07 from (216.180.4.179):
In Reply to: Re: Re: Ford 3000, hydraulic/transmission fluid level posted by Eric on June 03, 2002 at 08:09:18:
Sitting in the seat to your right hand side. there are two one for the tranny and one for the rear end they are npt type pipe thread plugs maybe 3/8 or half inch square on the head they are on the side of these housings.the tranny holds 13.2 quarts the rear 25.2. your FNH dealer can tell you the type. I pretty sure you can buy it at wall mart.
Follow Ups:
Home
| Forums
Today's Featured Article -
Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|