Harry Ferguson Tractors Discussion Board |
Re: Re: v-belts for Ferguson sickle bar
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by '52 8N (MD) on July 03, 2003 at 09:30:31 from (209.163.100.9):
In Reply to: Re: v-belts for Ferguson sickle bar posted by James, UK on July 02, 2003 at 06:21:25:
Thanks for your input. I found JDV-belts.com and the fella there shared the elusive formula with me: Sum of Outer Diameters of pulleys times 1.57 plus 2 times median distance between centers of pulleys. For my 6A-EO-B20 mower this is: [8"+ 5.5" X 1.57] + [2 X 10.25] = 41.695" The tricky part is knowing that the DayCo/Goodyear belt numbers need to be adjusted upward by a half of an inch to compensate for the pitch of the belt. So say the DayCo number is 24408 (First two digits are in 32nds of an inch 24/32" belt width by 40.8" length, the last three digits). To get to the compensated effective length that equals the output from the formula above you add a 1/2". So since I needed a belt with a nominal length of 41.695" the DayCo 24410 is a good match - 24/32" = 3/4" width by 41"+.5"= 41.5". Again, thanks for putting me on the right track. Without your post I wouldn't have known to ask for the formula. wc
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|