Posted by wbradley on April 13, 2014 at 21:17:55 from (209.152.128.202):
In Reply to: ferguson t020 brakes posted by wbradley on April 13, 2014 at 07:03:11:
Brake shoes look ok. Drum looks ok. I had to free up the brake stop assembly. So i had it all apart. i thought i may not have put it back right. All joints are free to move. With the back end jacked up, i can push on the right brake and the right wheel will stop. But when driving the tractor, i don't have much brake at all.
The master brake doesn't brake at all. The part about the brake stop not hitting the brake shaft make me think that the linkage is not right. When the brake stop hits the brake shaft, pressure on the master brake pedal will rotate the brake shafts to the rear which moves the shoes against the drum?[/quote]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.