dont mean to hijack this post, but you answered a question for me that i was getting ready to post on here. I too have a TO20 ser# 28804 that evidently has a replacement block. my mounting bosses arent drilled either, and i have the oil filter mounting boss. someone made an alternator mount for mine that bolts on the same place as the first pic, but raises the alternator higher to allow for axle pivot. on the other side of block where the z number is, mine has z12 raised and cast in, then a flat spot with just the number zero stamped in making z120. it also has no rivets at all above starter where serial number plate goes. this answers my questions before i ask them. is there any advantage having the 129 block over the 120 ie thicker cylinder walls maybe?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.