Posted by Vonderbach on September 30, 2013 at 13:17:22 from (22.214.171.124):
In an effort to combat an eternal struggle against a rusted gas tank, I finally broke down and purchased a new tank. However, after installing the tank my TO35 has no "umph!" Idle is great, although it sounds a little diesely (if that's a word.) And even high engine speeds in neutral are ok, but the rev is slow to increase and pops a lot.
But most importantly, when using the PTO and/or moving, the tractor has no power at all. It barely moves under its own power and if I'm on an incline it runs at extremely slow engine speed without any response from the gas lever.
I've tried adjusting the carb multiple times, and I cleaned it prior to replacing the tank. I bought a rebuild kit as my last effort, but I was wondering if anyone else might have any thoughts or suggestions?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.