Posted by oldmisterbill on September 02, 2013 at 20:45:12 from (74.195.218.85):
I have always had my bush hog behind my Case 300. Now its going behind my TO-30 I have some ideas on how to prevent sway -maintain cutting height , etc. BUT! I never really have seen either a Ford or Ferguson hooked to any thing but a plow ot counter weight, and that was 50 years ago. I would welcome pictures and ideas (homemade or factory) preferably pictures. I have some pieces that look like they were used in 3pt setups.
I can do it my way -but is my way the best? I am not sure,so I welcome feedback.
By the way I found a generator with the tach drive (no warranty) $125.00. Guess I better get it so I can get rid of the alternator. The good is they start so easy the generator woill keep up easily. Does anybody know what the 12 volt amperage was?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that ‘quick look over’ before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.