Posted by IrvIA on March 23, 2013 at 18:41:03 from (207.199.229.145):
In Reply to: Ferguson Mower posted by miner09 on March 21, 2013 at 16:36:32:
Those things are a sonabugger to put on for the first time. We had one in the 60's and cussed it every time because we only put it on once or twice summer. If you had to put it on once a week, I think there'd be nothing to it. A word of advice, get someone to help you if you want to keep the paint on the inside of your rims. That right side breakaway bar will swing under there and skin it up for sure. Don't ask me how I know that. Steve is correct on the pins. They are actually short bolts that bolt to your bracket and take a nut like a wheel nut instead of a clip pin. You can see the divot for it on the inside of the arm in the picture. I found mine at Tractor Supply if remember right. Those orginal cast brackets you have should work perfect with the correct amount of offset. I'm sure you know this, but the hole in the bracket goes to the front, and lines up with the bolt on the lift arm. (I put mine on backward once). It looks like the one in the picture is correct. That is one nice looking 40. Have you got another picture? Irv
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.