Posted by Langus on December 01, 2012 at 17:00:57 from (173.29.240.191):
Well....today our sand blasting was rained out after just getting setup. We will try again tomorrow.
So, while it was raining outside we decided to tackle some issues that have been sittin on the shelf. The front of the front axle support where the pin slides through, the single bolt in the pin was broke off. While trying to remove the broken bolt, the small plate under the pin came loose. I can find this section in any of the parts breakdowns or online. I have attached a pic of this part in my vise. It did have 3 small tack welds holding it to the main assy but they looked very weak and poorly done. Not to mention, I was able to break all 3 just trying to remove the broken bolt. Is this part originally part of the main assy or was it added? I have attached a pic of the main axle assy with the small plate removed from the front of it. Do I need to clean up the welds and re-weld it back in place? Thanks for the help!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
