Posted by DON TX on October 19, 2012 at 19:32:21 from (76.196.0.42):
It surprised me to find it is cast iron instead of sheet metal = good. Had to remove flywheel shield to install = ok. Had to install all bolts before tightening in order to get all bolts started = ok. Went to install filter cover found it was concave instead of bulged like original, cover bolt hole was not big enuff to allow stud to pass thru the cover = bad. Not sure if it would work w/o modifying and didn't want to drill out hole, so I ground the weld off the oem pan and used the original cover = good. Tightened everything up and filled with oil. No leaks = good. Started it up and got pressure, no leaks, ran it till the radiator puked and puked and puked some more. Got worried and killed it. Checked water level and still above core. As far as I can tell it is circulating, thermostat is open so I figure it was overfilled. Will run tomorrow and see if it pukes again. Really want to put this thing back to work. DON TX
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
