Posted by John(UK) on September 21, 2012 at 09:28:06 from (79.76.249.53):
In Reply to: pto not engaging posted by greg elsenrath on September 20, 2012 at 06:51:46:
A few things could have happened here, if the PTO shaft from the HOG is tight and it is hard to "telescope" into the other half, it could have pulled the PTO out of the gear inside, but usually it will show at the back end as the shaft will stick out more than it used to do. You could have broken the PTO shaft in the tractor but it is unusual. You would need to pull the PTO out to check that. DON'T try the suggestion of dropping the front wheels into a hole to save draining the oil, all this will do is fill the Clutch Housing with oil if the oil seal is worn, it is OK if the seal is good but not when it is worn. You can pull the PTO shaft out without too much trouble, just four bolts and pull it out after draining the oil. Being that the pin in the ORC has broken, that is a clue that the pin was overloaded and that is why it broke and the cause could be that the PTO shaft on the Hog is tight, you should clean this anyway and make sure that it slides easily. If the Hog has been lifting too high then the PTO shaft will be bent. If the shaft was tight like it seems to have been, it could be the ORC has pulled apart as well. You will need to look closely at it. Because you didn't have anything on the PTO when you tried it after replacing the Pin it is quite possible that it would turn without any load on it, when you fitted the Hog again, that would prevent it turning. Now I have the information about your tractor and the type of Bush Hog you have I can now send you the information that I mentioned a couple of days ago....John(UK)...fergusontractors@hotmail.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
